Introduction
This Clamp Lock installation training course focuses on the installation and maintenance of Mark II Clamp Locks for plain leads and single slips with reference to double slips and switch diamonds.
Objectives
On successful completion of the course the candidates will be able to:
 | Install a Mk2 clamp
lock to a plain lead in accordance with the Clamp Lock Handbook
| Carry out maintenance
on a clamp lock fitted plain lead in accordance with the Signal Maintenance
Specifications Volume 2 PB11 and PB15
| Carry out first line
faulting on a clamp lock fitted plain lead in accordance with instructions
in the Signal Maintenance Specifications and the Clamp Lock Handbook
| Carry out a point care
pre-inspection on clamp lock fitted points in accordance with instructions
in the Clamp Lock Handbook
| Carry out a point care
service on clamp lock fitted points in accordance with instructions in the
Clamp Lock Handbook | |
Content
| Principles of clamp
lock operation, Installation and adjustment of Mk2 clamp locks to a plain
lead
| Maintenance to clamp
lock fitted points to services A, B, C and D
| Fault Location and
rectification
| Carry out disconnection
procedures in accordance with Rule Book section E
| Carry out point care
procedures
| Rectify any identified
defects during a point care service | |
Who Should Attend
Candidates whose work involves the installation and maintenance of clamp lock
points
Learning Approach
Classroom sessions and practical work. Theory and practical assessments are
included.
Features
A school environment with the ability to have faults applied. This environment also allows component changing under controlled conditions and where appropriate the equipment may be stripped and re-built. This is a Learning environment without distractions. Theory and practical assessments are used to test the course objectives and candidate knowledge.
Booking Code: CLIM
Duration: 10 days